Grow Timeline (14 updates)
Today was the first watering. The seedlings are looking pretty happy. The clone not so much, but I think it’s going to bounce back. I thought my humidity in my tent would be high enough for the clone to just root but it wasn’t happy after the first night in the tent. I’ve been keeping a humidity dome over the top of it and misting the dome multiple times a day until it looks happier. Fingers crossed
Nice start, let’s go
I was forced to transplant the seedlings today because they were outgrowing the solo cups pretty fast and needed a watering. I’m sure they will love their new 3 gallon homes. The clone is looking great as well. All of the plants recieved a small dose of cal mag, big bloom, and grow big.
The clone is really starting to take off in growth. Yesterday it spent almost the entire day without the dome on. I think after today I don’t need itanymore. Lights increased last night to 75% and lst on the clone. I’m going to try to root the top of this plant when I eventually top it.
Edit- last two pics are in the afternoon after I tied down the top
Watered all three today. They got their first dose of silica. Cal mag also upped to full dose. Time to lock in and get these plants spread out and ready to flip. Lights also at 75% and around 18inchs away from the highest point on the clone
This MAC clone is growing great so far. Today I added more tie downs, did a small defoliation on the bottom of the plant, and super cropped the previous main cola. The Zoap plant seems to be pretty light green. I think I’m going to have to up my dose of cal mag and nutes during the next feeding
I had a new ph pen show up and figured out that my previous was reading 0.6 higher. Today I watered full dose silica, cal mag, and nutes. All pH 6.4 hopefully they will start to bounce back. If they look happy I will probably flush them the next time they are thirsty. I tied the tops down on the Zoap and White Widow plants.
If it dont straighten out raise the light a tad bit I see some taco leaf happening but over all still looking like an amazing grow
So i put ur pic into the ai plant dr in the tools section i asked if it was overwatering cause thats what i thought this is what it said Let's analyze what I observe in the image first: 1. The cannabis plants in fabric pots appear to have some downward curling and drooping of leaves. 2. The leaves show a mixture of healthy green areas and some curling tips. 3. The soil surface looks moist but not overly saturated from what can be visible. 4. The environment looks controlled with a fan for airflow and some humidity control device present. ### Most Likely Cause These symptoms—drooping leaves with some curling—can indicate overwatering, but they can also be caused by underwatering or environmental stress like high humidity or low airflow. ### Why It Fits - Overwatering causes root oxygen deprivation, leading to droopy leaves. - Underwatering causes drooping due to lack of water turgidity. - Environmental factors can also cause similar symptoms if airflow or temperature is not ideal. ### How to Confirm - Check the moisture level at the root zone by feeling the top 1-2 inches of soil. If it is wet and heavy, likely overwatering. - If dry and light, it’s underwatering. - Check temperature and humidity (ideally 22-28°C and 40-60% RH). ### How to Fix - If overwatering, allow the soil to dry out before watering again. Increase airflow around the base. - Adjust your watering schedule and only water when the top soil is dry. - For underwatering, increase watering frequency. - Ensure good ventilation and maintain correct environmental parameters. - Repot in well-aerated soil if water retention is too high. ### Secondary Possibilities - Nutrient imbalance can cause leaf curl. - Light stress or heat stress could contribute to curling. - Root problems like root rot if overwatered for a long time. --- Please provide the following for more tailored advice: - Your watering schedule and volume per watering - Medium type and drainage (soil, coco, etc.) - Environment conditions (temp/humidity/light type/distance) - Growth stage (veg or flower) This will help pinpoint whether it’s definitely overwatering or another cause.
Those are some fat leaves? It might just be the pic but I think those are the fattest leaves I’ve seen on a widow that’s pretty cool
I think the light was the main issue. I’ve backed it off and the leaves are starting to taco less.
The clone was getting dry and needed water. Since I got the new PH pen and I know my soil PH was probably still recovering I decided to flush it. Ph of water 6.3. I also raised the light back up a few inches. I think the light was stressing the plants
I flushed the two seed plants with PH 6.4 plain 100ppm water. The run off read ph 6.1 with 1320ppm! Still maybe a little more work to go with correcting by mm the nutrient lockout that I had started with the old ph pen. Lesson learned- calibrate your shit often! I’ve backed the light off a little as well and the plants are responding happily. Finally I added more LST to each of the seed plants.
😳 hope yuh get it figured out
I'm running the Zoap strain too myself right now. She's in the second week of flower. Can't wait to see her at harvest. 💪 Good growing growmie.